The Cupra Born is a five-seater five-door warm hatchback. Priced from $59,990 before on-road costs, it has up to 511km of claimed driving range and is available in a single battery and drive configuration.
The electric car can be charged at up to 11kW AC/170kW DC using a Type 2/CCS2 port.
How to Charge a Cupra Born
Cupra Born Charging Port
The Cupra Born charging port uses the CCS standard, which features a combined AC and DC inlet port. The top portion of the inlet is for the Type 2 connector, which is used for AC charging at home, work or at public chargers (e.g. shopping centre car parks).
For public fast/rapid DC charging, both the upper and lower sections on the inlet are used to support the high power output required. The Born CCS charging inlet is located on rear right side of the vehicle.
The Born can be slow, fast and rapid charged from public charging stations. In most cases:
- Slow charging requires a three-pin to Type 2 cable, usually supplied with the car.
- Public AC charging will feature a tethered Type 2 connector or may require a Type 2 to Type 2 cable.
- Rapid DC charging uses a tethered CCS connector which is part of the charging unit.
1. Find a public charging station for fast and rapid chargers
Plugshare is the easiest way to find any public AC and DC electric vehicle charging station in your area. It displays a map and overall rating of each charger from check-ins and comments.
Additionally, use the charging provider’s app like Chargefox or Evie Networks to view the live availability of stations and check whether a stall may be out-of-action.
2. Connect charging cable to car
Driving up to the charger, ensure that your vehicle’s charging port, located on the front right, is nearest to the stall. This may require you to drive in or reverse into the charging spot.
Once parked, grab the appropriate charging connector type from the stall’s holster, open the Born’s charging flap and any other caps, and firmly plug it into the vehicle.
3. Confirm charging has started
Use the charging provider’s mobile app or tap the RFID card on the stall to activate the charging session. You may need to press a start button on some charging stalls, too.
After a few seconds of communicating with the Born, you can see the charging status via the station’s screen, the vehicle’s driver instrument display, or the "My CUPRA App".
Cupra Born Charge Time and Speed
Level 1 and 2 Charging (slow)
Level 1 and 2 Charging refers to charging from a power socket or a mounted charger. This is typically done at home, work or shopping centre car parks.
The Cupra Born is capable of charging at a maximum of 11 kW with its onboard charger, however this requires a three-phase power supply and charger, typically found at public car parks or business premises. The power supply in homes is likely single phase, meaning the maximum power you can draw from the onboard charger is ~7 kW.
Charging an Born using a portable charger and a standard 10A power will add 16km of range per hour. A full charge would take 36 hours. Upgrading the power source to 32A, will increase range added per hour to 68km and reduce the charge time to less than 8 hours.
Level 3 DC Charging (fast, rapid)
The Cupra Born can support maximum DC charging of 170kW, chargers with higher output than this will be throttled to this limit. Charging the Born from 10% to 80% at a fast/rapid DC charging station can be done in as little as 34 minutes, providing 408 km of range.
The following tables show the estimated time to charge the Born using different speed fast/rapid DC charging stations.
It is recommended to limit the charging at rapid chargers to 80% to preserve battery health.
Note that the times shown are only a guide only. Other factors that might vary the actual charging time of your car. For personalised estimates of the Born, use the zecar ev charging calculator.
How Much Does it Cost to Charge a Cupra Born?
The below tables show the estimated cost of charging the Born's 77 kWh battery at home using a standard flat tariff or a public fast DC charger.
Based on these figures, the Born's fuel costs are $4.2 to $10.1 per 100 km, depending on the type of charging. In general, home charging provides the cheapest per kilometre cost and public rapid charging tends to be around double the cost (per charge and per kilometre). This compares favourably to an equivalent petrol car which would cost $15 per 100km, assuming $2/litre for petrol.
Use the zecar EV charging calculator to find the cost and times to charge any EV using any charge method. The results can be personalised for different electricity costs and the level of charge required.
What is the Recommended Charge Level for a Cupra Born?
Cupra Born Charging at Home
The Cupra Born is compatible with almost all portable and wall-mounted chargers.
The Born comes with a portable charging cable, which can be used on any Australian domestic power point.
For faster charging speeds, you may want to consider a wall-mounted charger to reach the maximum 11kW charge rate the Born is capable of.
Home charging while taking longer will likely result in less degradation.Electric Car Home Charging Guide
Cupra Born Charging using Public DC charging stations
The Cupra Born can be charged using all the major charging networks except Tesla Superchargers and some select Tesla destination chargers.
Refer to this guide for all the key public charging providers including links to app downloads.
Excessive use of fast charging may accelerate the degradation of the battery due to the heat caused by fast charging.
Charging a Cupra Born Bottom Line
Stay up to date with the latest EV news
- Get the latest news and update
- New EV model releases
- Get money savings-deal